IMG_2145
Foam Kits

1DNator Kit

$25.00

Made from Durable Model Airplane Foam. This is 1 Unique plane. Large airfoil shaped wing and vertical stabilizers, allow this plane to take off vertically from the ground. In this Kit version, you can add your own LED lights inside the wing for Night flying. You can add LED’s all over it for an awesome night flyer. Aileron and elevator controlled.

Any Brushless motor can be used. We are using a CF 2812 1534KV Brushless Outrunner motor, 20 Amp ESC and a 1300mAh 3 cell Li-Poly pack with an 8 x 4 prop.

Out of stock

Glue the spar and ribs into opening in wing.  Fold and Glue the top and bottom wing together. Glue the firewall to the back. Push the Fins thought the wing and then glue in place.  Make sure to use Foam safe glue.

Mount engine on the firewall and begin dry placing radio gear into place. We need to balance the plane at 2” to 2-1/2” back from front point of wing.

The Speed Control and Receiver should be placed in the center section of the wing. Glue the servos into place in the opening in wing.

The model flies with little up trim for level flight. Adjust surface deflection for 3/8” travel in both directions. Increase or decrease surface throw after first flight.

1DNATOR Assembly

 

Additional information

Weight 3 lbs
Dimensions 32 × 24 × 4 in

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.