Eluminator kit
Foam Kits

Eluminator Kit


Eluminator Kit only.

Made from ModelPlaneFoam

6 in stock

Any Brushless motor can be used. We are using a CF 2812  1534KV Brushless Outrunner motor,  20 Amp ESC and a 1300mAh 3 cell Li-Poly pack with a 7 x 6 prop.

Glue the spar and ribs into opening in wing.  Fold and Glue the top and bottom  wing together. Glue the firewall to the back. Push the Fins thought the wing and then glue in place.  Make sure to use Foam safe glue.

Mount engine on the firewall and begin dry placing radio gear into place. We need to balance the plane at  8-1/2”  back from front point of wing.

 The Speed Control and Receiver should be placed in the center section of the wing. Glue  the servos into place in the opening in wing.

 The model flies with little up trim for level flight. Adjust surface deflection for 3/8” travel in both directions. Increase or decrease surface throw after first flight.



Additional information

Weight 2 lbs
Dimensions 26 × 6 × 20 in


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.